A good default setting is 1. After that you can continue to turn them out with a rpm gauge connected. Then gauge needs to be accurate. Some timing lights will show rpm. Turn each one out separately until max rpm is reached. Ideally a exhaust gas analyzer is best to use as it will take into effect engine wear.
P0171 FORD - Fuel Injection System Too Lean Bank 1
P FORD Fuel Injection System Too Lean Bank 1
In some EEC countries though not yet in the UK it is an offence to drive a vehicle with broken or missing tamperproof seals. Before disturbing a tamperproof seal, satisfy yourself that you will not be breaking any local or national laws by doing so, and fit a new seal after adjustment is complete where required by law. Do not break tamperproof seals on a vehicle which is still under warranty. Note: Before carrying out any carburettor adjustment, ensure that the contact breaker points, ignition timing and spark plug gaps as applicable are set as specified and that the distributor is operating correctly where applicable. To carry out the adjustments an accurate tachometer will be required and the use of an exhaust gas analyser CO meter is also preferable. This is necessary so that the cooling fan runs continuously during adjustment. The CO reading should then be as specified.
Fuel mixture ratio for Yamaha rt? Answering "Where is the fuel mixture selonide on a Isuzu Pup? The fuel mixture for a Stihl chain saw is gas and oil. The fuel mixture is controlled by the computer and is not adjustable.
The exhaust manifold is of cast iron construction and incorporates a heated air box as part of the air inlet system on carburettor models. The exhaust system fitted as original equipment is of single or two section type incorporating a silencer and expansion box and suspended on rubber mountings under the car. Emission control consists of reducing the emission of noxious gases and vapours, which are by products of combustion, into the atmosphere.